Well the story goes like this. I decided it was time to improve the braking system on my TBA. Installed new stainless front and rear brake lines. Installed new front and rear pads (SBC's from Brent) and currently waiting for the front EBC disc from Brent. Everything went fine with the front brake. But... the rear just doesn't seem the wanna bleed correctly. I bled the guts out of it and can't seem to get barely any pedal on the rear brake. I mean that pedal goes almost to bottom before it really takes ahold. Before that the pedal would start taking ahold about 1/3 of the way. I followed the service manual step by step and used a brake vacum bleeder also and can't seem to make any headway. I finally concluded the piston in the master cylinder must be going bad, so I ordered a new piston and spring for the master cylinder. Anyone ever experienced this problem? Any input would be greatly appreciated.
Kerby
