I use the old fashioned, seat of the pants, method:
Tighten the bolt until it snaps off, then back off
a 1/4 turn.
But seriously folks, I did impulsively buy a Husky,
click type, torque wrench from home cheepo. When I
looked at it at home, I realised that it only reads
in ft/lbs, not n/m. I also have one of the bar type
deflection ones that has both scales.
What I need is a conversion table from n/m to ft/lbs,
so I can use the clicky one. Any ideas?
Uncle Charlie
