drilling slides

Check out the new Gallery

wicked red 1100
by mag10, August 21

first ride
by NemoJr, April 1

Steve McQueen inspired
by Feral, November 28

GaRally22
by chy, September 18

Print Thread

drilling slides #90938 08/21/2006 3:59 PM
Joined: Aug 2006 Posts: 321 Austin, TX sweatmachine OP Adjunct
OP sweatmachine Adjunct Joined: Aug 2006 Posts: 321 Austin, TX	Hello, I have an '06 Bonneville T100, 865cc motor. I want to drill the slides to 3mm, but I heard on the later models the slides may already be drilled out to the max. Can anyone offer any insight? Thanks! There is no greater thrill than being shot at with no consequence. -Churchill

Re: drilling slides sweatmachine #90939 08/21/2006 4:07 PM
Joined: Jan 2005 Posts: 6,308 Likes: 4 Honeoye, New York Dinqua Worn Saddle
Dinqua Worn Saddle Joined: Jan 2005 Posts: 6,308 Likes: 4 Honeoye, New York	The 06 models already have the larger diameter slide hole. A word to the wise is not necessary. It is the stupid ones who need the advice. Pat

Re: drilling slides Dinqua #90940 08/21/2006 4:08 PM
Joined: Aug 2006 Posts: 321 Austin, TX sweatmachine OP Adjunct
OP sweatmachine Adjunct Joined: Aug 2006 Posts: 321 Austin, TX	Thanks! You saved me a headache, but dang, I was hoping for a free upgrade... There is no greater thrill than being shot at with no consequence. -Churchill

Re: drilling slides sweatmachine #90941 08/21/2006 4:29 PM
Joined: Aug 2006 Posts: 153 Hanover PA SCCTrim Adjunct
SCCTrim Adjunct Joined: Aug 2006 Posts: 153 Hanover PA	Quit yer whinin....you already have all the upgrades in the t-100 http://www.sccinc.us.com

Moderated by chy, Dinqua, freedom

Link Copied to Clipboard

2025 Arkansas Rally
by roadworthy - 04/24/2025 7:57 PM

Bonneville America Forums Forums Technical Forums Performance Mods drilling slides