To undo, or do up the cables, I do this. Loosen them at the grip as much as possible, then loosen the one on the carb that is on the left, whichever that is. The top nut on that is easiet to get at with a wrench (8mm). So I release that cable from the BRACKET on the carb, but not the actual throttle. That gives me enough slack to remove the cables. Putting them back on, I put the pull cable in first, and fish the close cable back behind the bar thru the housing, I put the ferrule partially into the hole, then run something small and smooth (a nail?) up under the cable till it can slide into the slot and push the ferrule in. Then replace the cable on the carb end, adjusting it back to where I had it, and take up the rest of the slack at the grip end of things.
Clear as mud?
Last edited by bennybmn; 08/14/2006 4:47 PM.
