Ahh. They just push right out the front. Then you just roll the rubber boot back a little so you can pull the bulbs out. (NOTE: The neutral and oil warning lights worked no matter what way the LED bulb was in. I havent done the turn signal yet because I need the 12V diode still.) Then they go right back in, like Ben said, Push the rubber boot up throught the hole put the lense back on, then push the boot back through the hole while pullng the rubber. If the rubber is all uneven, just pull the rubber from the bottom and wiggle the lens. It will just pop right in.
Quote:
Those bulbs are such a pain to get out anyway that I wouldn't even bother unless you REALLY need them brighter. REALLY!
Don't let this scare you away from this mod. It is not hard at all. No complications. They are definatly brighter. They work awesome and are a perfect fit.
Now where are those darn 12V diodes? Off to E.P.O. I go. (electronic parts outlet)(it's a electrical/etc. store around here)
I'm ready for those rubber comments to get played on. 
