Outsider,
"If the throttle is lightly "blipped" at idle, and the rpm "hangs up" before dropping to the set idle speed, and there are no intake leaks and the idle speed is set at less than 1000 rpm, the mixture screws are probably too lean: try 1/2 turn out, to richen mixture. Be sure there are no intake leaks and the idle speed is set at less than 1000 rpm!" from
Factory Pro Greybeard,
Quote:
The trick is to ease the choke out just a little. If it gets better, you need bigger pilot jets. If it gets worse, go smaller.
How far out is a little? Between zero and 1/4?
