Yes, I plugged in a resistor to the ai harness connection when I removed the injectors.....and no, I removed the O2 sensors after running for a couple of weeks to see if the check light would come on.Again, I'd previously plugged in a couple of resistors to the wiring harness connectors for these as well.
It's always possible that I simply didn't notice the pulsing vibes before the tyre change....though unlikely as I'm fairly fastidious about how my bike runs
I've just had the dealer run a diagnostic check last week...all was well except of course that the O2 sensor no longer gives a variable reading as it isn't there.....so this showed up as a ' fail' on the test....but that's to be expected once the O2 sensors are removed isn't it?
I'd done about 800-1000 miles with the sensors and ai removed without noticing any problems
