I got it today.
The problem wasn't getting the clip on, it was getting the plate on the pins. TIGHT FIT!
A little hand held press finally got it on.
BUT THEN, I couldn't see the grooves in the pins, to know when the plate was on enough to add the clip.
mic'd it (the width of the link), and it was the same as the standard links, but still couldn't even see the beginning of any groove. Also, couldn't find the clip.
Came to the conclusion now, seeing that there is ALSO little dimples (holes) in the ends of the pins, that THIS link must be a rivet link! DAMN IT MAN! That is NOT what I wanted!
I don't even have a rivet tool.
