Check out the new Gallery
wicked red 1100
wicked red 1100
by mag10, August 21
Windshield I need to replace
Windshield I need to replace
by philwarner, May 10
first ride
first ride
by NemoJr, April 1
Steve McQueen inspired
Steve McQueen inspired
by Feral, November 28
GaRally22
GaRally22
by chy, September 18
Previous Thread
Next Thread
Print Thread
TP usa high performance kit?
#550769 07/19/2014 11:33 PM
Joined: Mar 2012
Posts: 262
tiger7 Offline OP
Adjunct
OP Offline
Adjunct
Joined: Mar 2012
Posts: 262
has anyone install this high performance kit from triumph performance USA? I am looking for a big gain in horsepower and torque Will this do this? and does anyone have the exact horsepower and torque gains that I can look at? I


"Get busy living or get busy dying. That's ****** right."-Red
Re: TP usa high performance kit?
tiger7 #550770 07/21/2014 9:57 PM
Joined: Mar 2012
Posts: 262
tiger7 Offline OP
Adjunct
OP Offline
Adjunct
Joined: Mar 2012
Posts: 262
Bump


"Get busy living or get busy dying. That's ****** right."-Red
Re: TP usa high performance kit?
tiger7 #550771 07/21/2014 11:37 PM
Joined: May 2010
Posts: 5,720
Ryk Offline
Check Pants
Offline
Check Pants
Joined: May 2010
Posts: 5,720
Are you considering the whole package, headwork, oversize valves, flatside carbs, adjustable timing, big bore jugs, cams, hi-compression pistons, etc. as there are a lot of levels and variations, it's hard to answer your question unless you provide just how far down the rabbit hole you want to go, not to mention what you can actually afford. Spec it out and you will get the feedback you desire, as almost every performance enhancement available has been explored by one or more members of this forum or over at the R.A.T. site.

Re: TP usa high performance kit?
tiger7 #550772 07/21/2014 11:50 PM
Joined: Mar 2007
Posts: 5,616
Check Pants
Offline
Check Pants
Joined: Mar 2007
Posts: 5,616
I did but I also had headwork, FCR carbs and a TTP igniter map done at the same time. Heres the write up on my adventure: Zmilin's build

BTW... when you start reading the thread it was not my intent to go the route of the HC pistons but if you read through the build you'll see thats what I ended up doing because of a stupid mistake I made with the cams.

Last edited by Zmilin; 07/21/2014 11:56 PM.

SOLD: 07 Black BA, 39mm FCRs, TPUSA stage 1 head, TPUSA 813 cams, TPUSA 10.8:1 pistons, TTP #3 igniter, Specialty Spares Long Cannons, Tsukayu Hard Bags. 82HP/55tq NEW: 19 Goldwing Tour DCT

Moderated by  bennybmn, chy, mert 

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.4