In case any rookies like me read this as it's time consuming to find, maybe this will help being my first time and all: after unscrewing the right side the front spindle (big nut on left fork) will come out by gently tapping it with a rubber mallet from the right side, and i think an 11/16 deep well using the same trick that has been posted with the 5/8 plug. It does not have threads and prolly won't just slide out. The extension comes in handy again inverting the deep well and tapping the extension to push it far enough to get it to pull out. Not knowing what to expect, i had my lift just high enough so i could put a piece of 2x4 or what have you under both tires to prevent rocking along with a safety strap on the frame, but you should be okay if you loosen everything before lifting. Depending on your lift, mine has two arms on each side that settle into notches on the frame when you slowly release the air, mine being on the second notch you hit on the way up. Then after you gently slide the wood out from underneath your front tire will come out at a little bit of an angle to the side as it should not clear the front of the fender or mud guard if you will. I am going to use a small dab of anti seize on everything threaded before reassembly. Cleaned spindle and will reapply lithium grease. As for putting it back together...
