I just want to be sure I did this correctly. Unfortunately I did a poor job of paying attention when I removed them so here is how I reinstalled them.
1. I cranked the alternator until the sprocket said 'top' at the top.
2. I checked where the piston was
a. If it was top dead center i move to step 3
b. If it was not top dead center I go back to step 1
3. I installed the cams, being sure to load the sprocket tension and lining up the dots and lines. Also making sure to put the exhaust cam in the front and the intake in the back.
Does this sound correct? I really don't want to start up the bike with this in the wrong position.
Last edited by crumb; 06/17/2013 12:28 PM.
