|
|
 anyone with a 2011 or newer TBA assistance needed
|
Joined: Jan 2011
Posts: 379
Adjunct
|
OP
Adjunct
Joined: Jan 2011
Posts: 379 |
hello all, i am in the process of running stealth electrical and relocating my turn signals on my 2006 TBA. i bought the BC relocators for the turn signals but since i have highway bars, the do not fit correctly. i love the look of the 2011 and up turn signal bar. i was wondering if anyone with a 2011 and up TBA could take a pic of the underside so i can see how the bar mounts? if you were especially nice if you could take some measurements of where the holes are, that would be great too. my thanks in advance.
|
|
|
Re: anyone with a 2011 or newer TBA assistance needed
|
Joined: Jan 2011
Posts: 379
Adjunct
|
|
OP
Adjunct
Joined: Jan 2011
Posts: 379 |
nobody???? come on guys!!! lol
|
|
|
Re: anyone with a 2011 or newer TBA assistance needed
|
Joined: May 2007
Posts: 5,068 Likes: 1
Saddle Sore
|
|
Saddle Sore
Joined: May 2007
Posts: 5,068 Likes: 1 |
the deafening silence is 'cause we all got old bikes 
|
|
|
Re: anyone with a 2011 or newer TBA assistance needed
|
Joined: Jan 2008
Posts: 1,174 Likes: 15
Learned Hand
|
|
Learned Hand
Joined: Jan 2008
Posts: 1,174 Likes: 15 |
I will look at it and see what differences there are.
05 speedmaster - 1100cc, 11:1 racing pistons, Carillo rods, thunderbike cams, ported and polished head, 2mm over intake and exhaust valves, Barnett kevlar clutch, scepter pipes, oversize manifolds, 45mm HSR's, TTP stage 4 firestarter
|
|
|
Re: anyone with a 2011 or newer TBA assistance needed
|
Joined: Jan 2008
Posts: 1,174 Likes: 15
Learned Hand
|
|
Learned Hand
Joined: Jan 2008
Posts: 1,174 Likes: 15 |
Quote:
hello all, i am in the process of running stealth electrical and relocating my turn signals on my 2006 TBA. i bought the BC relocators for the turn signals but since i have highway bars, the do not fit correctly. i love the look of the 2011 and up turn signal bar. i was wondering if anyone with a 2011 and up TBA could take a pic of the underside so i can see how the bar mounts? if you were especially nice if you could take some measurements of where the holes are, that would be great too. my thanks in advance.
just so we are talking about the same thing. you are looking for the holes in the lower tripple clamp right?
if so, on the 2012 there are 2 each M8 threaded holes in the underside of the lower triple. the right to left centerline spacing of the ones you are looking for is 80mm.
if its any help that is the same as the spacing on my 05 as well (except those are thru holes)
05 speedmaster - 1100cc, 11:1 racing pistons, Carillo rods, thunderbike cams, ported and polished head, 2mm over intake and exhaust valves, Barnett kevlar clutch, scepter pipes, oversize manifolds, 45mm HSR's, TTP stage 4 firestarter
|
|
|
|
|
|
|
