Quote:

I did it a few years ago Mike, and the only thing you have to watch out for is to make sure you cut on either side of where those little plugs sit inside the handlebars that the stock bar-ends screw into, and which of course if you cut on the inside those little plugs and towards the middle of the handlebars, you won't be able to use the stock bar-ends anymore.

(...but seein' as how you said you already have aftermarket grips on your bike, this probably won't matter anyway)




thanks Dwight, ya i don't care its an extra set of bars i bought to try a couple things with, thought was to cut the ends off, this will push the full control assembly right up to the first bend in the bar, then powder coat them black, not sure if the 1/2 inch on each side is going to make a ton of difference but should make it better if thats my alternative to the oem speedy bars

2007 Speedmaster and miss it! 2013 T-Bird Storm and Luvin it! Catching a yellow jacket in your shirt at 70 mph can double your vocabulary