Edwin,
Do you have any suggestions for wiring up the HLY-3016? My bike is an 09 EFI.
Wiring Colour Code for Gauge HLY-3016:
Pin # on Gauge - Function - Bike wire
White - Output speed signal - ?
White/Purple - Tachometer warning output - For later install
Black - Ground for gauge - Connect to existing.
White/Green - Neutral indicator - 2 wires. 1 to console light harness. Marrette black wires.
Pink - Engine Indicator - Wire off the existing speedometer.
Green and Orange- Right/Left turn indicator - 2 wires. 1 to console light harness. Marrette black wires.
Yellow - Tachometer signal input -
Gray - Speed signal input - For inductive pickup’s, connect one terminal from the pickup to ground and connect the other terminal to the gray wire on the gauge.
White/Red - Speed sensor power out - ?
Red - 12 volt power with key on - Connect to existing 12v source.
Brown - Low oil warning indicator - 2 wires. 1 to console light harness. Marrette black wires
Blue - Night diming - Not using
Purple - High beam indicator - 2 wires. 1 to console light harness. Marrette black wires
White/Blue - Optional external switch input - Not using
White/Black - Security system indicator - Not using
Last edited by BANomad; 05/06/2015 2:10 PM.
