Quote:

I just unplugged mine at the other plug, its about 6 inches back from that in the picture, kind of a triangular shaped connector. However if you want LC Fabrications makes a blank off plate if you choose to take out the sensor.



Ok, so I just unplugged this sucker. Here's how I did it:
While holding a flashlight down onto the plug with her left hand I had my wife, using her right hand and a pair of needle nose pliers,come up from under the carb. and grab the bottom part of the plug making sure the release tab portion of the plug was facing upward toward the light so we could really see what was going on.
From the top I reached down with my left hand and grabbed the other section of the plug and with my right hand using a flat nose screwdriver pushed the release tab in and gentle wiggled the plug apart.... piece of cake!
Of course this "set up" took us about a half hour of finagling to figure out....

Took it out for a quick spin ...no popping WHAT SO EVER.
I had a couple beers in me so took it back in,tomorrow we'll give it a true running.
Anyway, just thought I'd share.

Oh, as far as the eliminator kit, I think I'm going to get one, don't see why not at this point (assuming all goes well over the next few days of riding)