So, I received my Techbike parts center stand last week and installed it today. The pins still do not clear the rear frame member of a 04 America. Off the bike and 5m with the Dremel, and... I did not take enough off, so off again and some file work to the rear of each pin. The pins did have a flat on them where they were machined, so I figured we were good to go now that it would swing down to the ground. Nope... the stand was a perfect 90 degrees when deployed. The bike popped off the stand while I was fitting the muffler back on. Twice more with grinding and fitting and now the angle is enough that you would have to bump the bike to roll it off. It will have to come off for more pin shaping before I could use it in a public place.
The moral of the story is... the one I received on the 18th still required some smithing then paint touch up.
