Here ya go ChuckyJ.....
The first thing was to locate a spare mustache bar and grind the frame mounts off the bar....
Then I marked the locations to re-weld the frame mounts back on so that the ends would face forward...
Then I had to grind off the control mounting ends so the could be rotated 180 deg. & re-welded back onto the mustache bar.....
Then I cut the control ends down so that the weld points for the upper & lower mustache bar were nearly flush/level....
Then measured out 2 lengths of 3/4 inch steel bar stock so that the finished span would clear the headers.... overall length was 19 3/4 inches (but an even 20 inch overall length would work just as well I figure)....the bar stock was cut @ 16 1/4 inches.....
And that is as far as I have gotten....to much work & stuff is keeping me from finishing this up. The end result should bolt right up to the frame mounts....& then some modifications to the shift rod & rear brake lines would need to be done to complete the whole project.
