OK, here are some photos, They came in a bit small, but should give you the idea. Guess I need to read some more on how to get full size pics in.
First a left side shot of the stand with the bike up.
Closer look with angle finder showing stand side is vertical
Closer view of stop pin on left side
Closeup of gusset angle; I assume this gusset should point up toward the frame if the stand was at the proper angle to the ground.
back of foot pad still sitting at a slight angle off the ground
I forgot to upload a pic of the stand above the frame rails with the pin interfering with the corner of the frame, but can add it if it would help.
The main issue for me is the potential instability of the stand because it stops before it goes "over center"; IE the foot pad is almost directly below the pivot bolt and not ahead of it.
