That's what my brain wasn't comming up with. The distance from the needle end to the main! So I just went out to the shop and put the caliper to them. Using my old eyes, contact lenses, reading glasses and the magnifing glass.(damn it's crap getting old) It looks like the difference is between 1/2 and 1 mm. A shim is .65mm. Not to much difference. I figure at worse it will run a little rich.
It is wednasday and I rode to work today, 108 mile round trip. I looded at the plugs and they look good, might be a tad lean, probably could have put a 130 in and been fine, but a 126 would have deffinetly been lean. I'd post a pic here but I don't have a way of doing that right now.
Last edited by monsterman; 09/21/2011 9:35 PM.
