You don't need any gaskets pull the cover carefully remove gasket from cover wipe cover down and gasket put a small bead of silicon gasket maker (I used gray) in the channel where the gasket goes let it set for about 15min or till tacky lay gasket back in reinstall
What happens is the gasket shrinks over many heat cycles and the cover can only tighten so much dues to the way the bolts are so you can't crush the gaskets the gasket maker fills in a little space so the seal is tight again i did this to mine 15,000 miles ago and still no leaks I was told to do this by a triumph tech
2005 America 145 mains, , #48 pilots, , k&n pod filters, ported intakes manifolds, nology coils and wires, pro com CDI, 62 HP at wheel 68,000 hard miles still runs great gone "traded"
| 
