Thanks SDKimo,
The basic problem here has been I have paid for something and got something else that doesn’t suit, so the supplier needs to send the right thing as opposed to me having to do all sorts of funny stuff just because they have stuffed up. It just gets a bit trying when they send the wrong thing 5 times.
I actually tried to fix the bars by putting a heat on them to flatten it out, and the bars got severely twisted so I had to through them away. Could have done it a few different ways but thought that was the easiest at the time – what I should have done was send them back (again)
The real lesson here is, if you are going for bars then are not 1” all the way through then make sure they are notched otherwise you have to spend time fixing them. If you want internal wiring AND THEY ARE T BARS then make sure they are drilled where they weld to the riser (dimples don’t really make a difference – but god dam it if I have paid for dimples then I want dimples)
I am know waiting for a new set of bars that will be made for:
Internal wiring (& dimpled) and are notched.
I have went through a custom shop this time, which means I don't have to pay for them or accept them until they are right. They now carry the burden of sending them back each time.
