Well my adventure into replacing my handlebars has been a bit of a disaster.
I can’t get the clamp to tighten all the way up due to the taper on the brake reservoir interfering with the handle bars.
Problem is the bars are 1”on the throttle and go up to 1¼” on the body, and that extra ¼ “ gets in the way of the brake reservoir.
Because the bars are dimpled I really need that clamp to tighten right up. I also have the ISO grips, which are a bit longer than normal making the throttle boss 1 ½ “longer than the bar so I can’t afford to slide them back anymore.
Anyone any ideas, used a different brake reservoir assembly, had the same problem. Did think about bashing or clamping it down to flatten them out a bit but I had has such a nightmare with them so far I am thinking I will just go to British customs and get these ones.
http://www.british-customs.com/triumph-america-speedmaster-radius-drag-handlebar-1-1-4.html
