Quote:

FRONT TURN SIGNAL RELOCATORS
FOR TRIUMPH AMERICA & SPEEDMASTER
#TA104 fits thru 2006 & TA104-70 fits 2007 & Newer
1. Remove the front turn signals as follows. The turn signal wire plugs are located inside the
handlebar switch housings. Remove the two Phillips screws located on the forward facing side of
the switch housing, remove the covers, unplug the turn signals and reassemble the switch
housings. Unbolt the signals from their black mounting brackets, remove the brackets from the
bottom side of the switch housings, reinstall the nuts and tighten securely.
2. Disassemble the two halves of the turn signal mounting clamps supplied, place the M6 X 25mm
button head screws thru the hole in the side of the clamp from the inside, place the spacers
supplied over the screw threads. Screw the clamps and spacers onto the turn signals. Hold the
signal/clamp assemblies up to the front fork, position the signals so that the housing/lens seam is
vertical and straight, carefully remove the assemblies from the forks and tighten the screws
securely. Install the signal/clamps onto the forks, set to the desired height and angle and tighten
the clamp screws securely.
3. Using a sharp knife slit the black wire loom from the turn signal plug back 7”. Pull the turn signal
wires and plugs out from the loom. Fold the wires along the loom going down towards the
headlight. Leave 2-3” of the wire next to the plug exposed and neatly tape the rest of the wire to
the loom and the loom closed back up to the handlebar switch.
4. Connect the signal wires to the plugs from the wire loom. Using the cable ties supplied tie up any
loose or unconcealed wire and the plugs.
RIVCO Products, Inc
440 S. Pine St.
Burlington, WI. 53105
Ph. 262-763-8222


Blowing gravel off rural roads