Bonneville America Forums Forums Technical Forums Custom Corner Soul Survivor's Bars

Soul Survivor what bars are on your bike, they look great?
Work with stock controls?

Anyone else know.

Thanks
Glenn

Back in 2006, he said:

"The drag bars are Barons Rad-ius Bars part# BA-731005-00.
They are made for the Kawasaki and Harley. There are pre-drilled holes for the wires. The ends of the bars were cut off 1" at each end to fit the diamond cut grips. Then the holes next to the grips were notched open another 1/2 inch to fit all the Triumphs wires(18!!). I wrapped the wires pertruding from the bottom of the bars in 1/4" steel braided line and then used clear shrink wrap over that to protect the wires."

Thread:

http://www.bonnevilleamerica.com/forums/...rt=all&vc=1

And then in 2007 he said:

"I have Barons drag bars. Stock length control cables will reach just fine if you have an America. They take the same route as stock. You can look at my photos in the photo section. Comfort is WAY better and there is no comparison with the looks."

http://www.bonnevilleamerica.com/forums/...rt=all&vc=1

I couldn't have said it better myself!

Wow, deja vu...

Thank you for the information. Where are the bars pre-drilled, the advertisement pictures does not show it? Can the holes be seen, if you dont run the cable through the bars. Thanks for the follow on question, it is much appreciated.

I'll let Doug take this one, live not Memorex.