SalMaglie posted this sketch:

Quote:

Here goes, but I have to warn you, my measuring instruments aren't what I would call the highest quality so I make no claims of 100% accuracy. And as you can see, I'm not a draftsman or an engineer. If you make one based on this drawing, I'd sure like to know if it works.

All dimensions are in inches. The distance between the retaining pins(2.16") is center to center as best as I could measure.



Both mine and Jay's drawings are what actually come in the kit when you buy the Triumph tool. There's the spanner, which allows you to rotate the sprung gear, and the 2 of the L shaped tools to pin the gear under tension.



And Jay posted this for the pins:

Quote:

Here's the measurements I made of my Triumph backlash retaining pins:



Of course all you really need is the 'business' end (the stepped end).

Here's a picture of the pins in action:



Good luck, and be patient doing the backlash check/adjust.
Lots of good advice available here!

jay


Last edited by bennybmn; 03/16/2007 6:09 PM.
Benny Black & Silver '02 Too many mods to list Not enough miles ridden