Intake / Carbs

Check out the new Gallery

wicked red 1100
by mag10, August 21

first ride
by NemoJr, April 1

Steve McQueen inspired
by Feral, November 28

GaRally22
by chy, September 18

Print Thread

Needle Shims specs Dinqua #42481 09/11/2007 8:08 AM
Joined: Jan 2005 Posts: 11,126 Likes: 13 Merritt Island, Fl moe Should be Riding
moe Should be Riding Joined: Jan 2005 Posts: 11,126 Likes: 13 Merritt Island, Fl	4 mm stainless steel washers from Ace or wherever. They are .50mm thick (.020 inches). Various historical credits, but member Popcorn spelled it out recently. Last edited by moe; 03/25/2013 6:53 AM.

Entire Thread
Subject	Posted By	Posted
Intake / Carbs	bennybmn	03/07/2006 8:58 PM
Carb info and mods	chy	03/24/2006 3:10 PM
TBS Needles	bonnyusa	04/04/2006 8:56 PM
K&N Filters and Cleaning	bennybmn	04/05/2006 11:57 PM
Adjusting idle mixture (pilot) screws	Dinqua	04/07/2006 9:54 PM
idle mixture (pilot) screw O-rings	bennybmn	05/17/2006 9:25 PM
Secret fuel filter	bennybmn	06/24/2006 6:04 PM
Drilling bottom of Airbox - Freak Alternative	Dinqua	07/29/2006 8:37 PM
Another Triumph tuning Manual	Dinqua	04/09/2007 12:36 PM
Air mixture screw diagram	bonnyusa	05/09/2007 1:06 AM
Needle Shims specs	moe	09/11/2007 12:08 PM
Re: Carb to Head Rubber, HT	moe	10/09/2007 2:08 PM
Re: CVK Jet Series Numbers	moe	11/13/2008 8:25 PM
Adjusting Throttle Position Sensor	wojo	11/14/2008 8:34 PM
Re: Carbs Brace(s)	moe	03/10/2010 5:32 PM

Link Copied to Clipboard

2025 Arkansas Rally
by roadworthy - 04/24/2025 7:57 PM

Bonneville America Forums Forums Technical Forums The Vault Intake / Carbs