thats probably going to be too big. I would probably get a piece if plumbers tape, 2 small "J" bolts with 4 nuts. small enough to go through the holes in the plumbers tape. run the plumbers tape over the back bone.
Use the "j" bolts to go under the back spacer bar that where the two carbs are bolted together.
Bend the plumbers tape at right angles leaving about an inch between the bottom of the back bone and the plumbers tape.
Double nut the "J" bolts through the plumbers tape ( one nut on each side of the plumbers tape )so that you can adust the "J" bolts up and down as needed to support the carbs properly.
do a test fit up then take it apart and pant it all. (not the threads of the bolts).
Last edited by locopony; 02/05/2011 12:36 PM.
