Up to speed:
Readers digest version:
06 TBA, thunder bike pipes, 130 mains, thruxton needles, ai removed, air box has 1 1/4" hole in the bottom covered with screen, stock air filter, floats set just below the top of the bowls, altitude 12' to 1300"
carbs off for the first time to change main jets found float level at a significantly lower spec.
looking for an small inline fuel filter
The bike still sputters in top gear throttle wide open pulling hard past 85 mph and it will act like its lean or running out of fuel. When fuel is drained from the petcock it looks like a good stream fuel. how about a new tap?
removed internal fuel filter.
waiting for new nology coils from newbonneville. One of the stock coil is no good
______________________________________________________
actual post:
Hi there i had my carbs off for the first time to change main jets i checked the float level and it seemed a significant lower then the 17mm spec has any one found this out to. thanks jim
Hi guys looking for an small inline fuel filter i have seen here before any one recall who sells it thanks jim
Hi guys I have a 06 tba with thunder bike pipes hole in the air box 130 mains thruxton needles ai removed and the internal filter, the floats were low i raised them just below the top of the bowls. The bike still sputters in top gear throttel wide open pulling hard past 85 mph and it will act like its lean or runing out of fuel. If drane fuel from the petcock it looks like a good stream fuel so is a pingel some thing i should look in to. thanks jim
Hi back again it was the internal fuel filter i removed and the air filter is stock with a 1 1/4 hole saw hole on the bottom covered with screen and a filter and the altitude is 12 to 1300 feet. I did use the jftting calculator i will check it again thanks for your help jim
Has any one run our bikes at the drag strip with better pipes hole in the air box rejet and a 16 tooth sprocket. If so what was the et thanks jim
I am planing to run it this year, would like to get an idea what it is capable of. Right now i am waiting for new nology coils from newbonneville. One of the stock coil is no good
