I have a question for those of you that have the Procom CDI. On the front page of the Manual it states:
" Warning: The maps downloaded or imported must be installed into position "0" only!"
Elsewhere it says to set the "arrow" to #5 based on my stock CDI. So it seems if I want to use any of the downloaded maps I should set the arrow to 0 instead of 5?
I'm probably reading too much into this, but I don't want to mess anything up. FWIW, I'm running it with map #10 and the arrow at #5. It's running a bit rough and I'm wondering if I should set the arrow to 0 and reinstall? I think I'm going to try map #9 as it seems others on here have had good luck with it.
Also, I'm assuming I can change maps with the unit installed as long as the ignition is off?
