Are Hubert and I the only ones with problematic procom puters?
(Dr_PC)
Quote:
I'm having serious issues with the procom CDI. When I first installed it, my bike did great. Then it started dying at stops. It would restart just fine and run. Then it started running rough. I reinstalled my OEM. Later I mounted my procom in a position to switch between OEM and procom. Reconnected procom and the bike ran good for about a minute then it started cutting up, backfiring like the plug wires were reversed and would go dead. It would restart fine then after about 30 seconds the same thing. I contacted procom and they exchanged it no problem...
(Moe)Quote:
I removed the procom CDI and re-installed the GILL CDI due to a shut down issue on idle when hot, then a stumble issue off idle when 50+ continuous miles are on the clock. All the symptoms of a coil going south. I tried two other coils off a used 07 speedmaster, new spark plugs, other spark plug wires. All that was left was to reinstall the GILL unit, which corrected the shut down and stumble issues.
Last edited by moe; 06/04/2010 7:43 AM.
