|
|
 America lace wheel offset & runout
|
Joined: Feb 2005
Posts: 209
Adjunct
|
OP
Adjunct
Joined: Feb 2005
Posts: 209 |
All,
I am in the middle of a wheel swap project on my 06 Speedmaster. Have purchased 05 America wheels and had the rims powder coated. Next step is to lace and true the rims. BUT I did not know at the time of disassemble that I needed the offset measurement. I have searched the net for the offset and run-out spec's but can not find them.
Anyone know what the offset is suppose to be on the front and rear?
Also what goal should I have in mind for side & vertical run-out?
Thanks!
'06 SM with T100/America Wheels (D&D's, 10.5 to 1 Wiseco pistons, TTP Igniter +3, K&N PODS, 150 x 40, FZ1 springs & TBS needles w/3 shims)
|
|
|
Re: America lace wheel offset & runout
|
Joined: Sep 2006
Posts: 1,457
Learned Hand
|
|
Learned Hand
Joined: Sep 2006
Posts: 1,457 |
The run-out is in the shop manual, I think. If no one else chimes in, I'll check when I get home. As for the offset, or "dish", You could true them up on the bike making sure they're centered.
|
|
|
Re: America lace wheel offset & runout
|
Joined: Jan 2005
Posts: 1,382
Learned Hand
|
|
Learned Hand
Joined: Jan 2005
Posts: 1,382 |
The side to side (Axial) runout is 0.6mm max.
The out-of-round (Radial runout is 0.6mm max.
I couldn't find any reference to the offset
These were found in the Haynes Manual.
Tony G
'03 America
|
|
|
Re: America lace wheel offset & runout
|
Joined: Feb 2005
Posts: 209
Adjunct
|
|
OP
Adjunct
Joined: Feb 2005
Posts: 209 |
'06 SM with T100/America Wheels (D&D's, 10.5 to 1 Wiseco pistons, TTP Igniter +3, K&N PODS, 150 x 40, FZ1 springs & TBS needles w/3 shims)
|
|
|
Re: America lace wheel offset & runout
|
Joined: Feb 2005
Posts: 209
Adjunct
|
|
OP
Adjunct
Joined: Feb 2005
Posts: 209 |
Quote:
The side to side (Axial) runout is 0.6mm max.
The out-of-round (Radial runout is 0.6mm max.
So for those of us that think in inches that would be .0236 max.
'06 SM with T100/America Wheels (D&D's, 10.5 to 1 Wiseco pistons, TTP Igniter +3, K&N PODS, 150 x 40, FZ1 springs & TBS needles w/3 shims)
|
|
|
|
|
|
|
