Bonneville America Forums Forums Technical Forums Accessories Front signal relocators

Does any body make front turn signal relocators for americas? I noticed rivco discontinued them.

Have you checked with Eddy ?

Hmmm...I looked at brent's site(newspeedmaster.com) and saw that the rivco front relocators are discontinued there.
Not at fast eddy's site yet...talk to him.

British Customs too.

Or fab your own? If you have some spare time you could make a custom mount? I made my own to mount mine on either side of my light bar. Sorry no pics.

One really easy option is remove the tins, and run 41mm harley relocators, and there not that expensive

how about this one? mounts under the lower triple clamp using existing holes.

I like mine.



ebay rear signals on front with simple bracket to headlight mount.

Oh man, reusing the long rear turn signal tubes is a great idea! If I didn't already have the Rivco relocators installed that's the way I would have gone.

Just for kicks I checked out the site I got my relocation brackets from and it looks like they've replaced it with this:

http://www.newspeedmaster.com/html/newbonneville_light_bar.html

I don't know about the signals, but I might try out the light bar. I was looking for a streamlined look and wanted to supplement the headlight.

Those were Mack Daddys who used to own a Speedmaster some time ago. I considered them some time ago but couldn't justify the amount he wanted. Look good.

Lonzo,

That is an excellent idea. Can you post a couple of close ups?

All I did was drill 3 holes in 2 pieces of aluminum flat stock from Home Depot. Rear holes went to headlight mount with longer bolt, middle holes for turn signals, front holes have tubing spacer with threaded rod and acorn nuts for rigidity. Been 2 or 3 years, now, still rock solid.
If I had known you were going to make me go out there and take pics, I'd have cleaned my bike up some.





Found some red lenses at a swap meet for the rear, going to re-do my sockets for running lights...



Before anyone asks, I don't know what the lenses are for. The vendor said, "I don't know...Honda?"

Now that I look at it, could probably do the same thing with a single piece of stock with two 90 degree bends instead of that through bolt business in the front.