|
|
 Any tricks to installing ISO grip
|
Joined: Sep 2009
Posts: 106
Adjunct
|
OP
Adjunct
Joined: Sep 2009
Posts: 106 |
Do I need to cut off the factory grips? Or just work the old ones off by prying them with a thin bladed screw driver?? V. 
|
|
|
Re: Any tricks to installing ISO grip
|
Joined: Jan 2005
Posts: 5,537
Check Pants
|
|
Check Pants
Joined: Jan 2005
Posts: 5,537 |
I just worked mine off, saved them, not sure why.
I used spray can hair spray to put on the new grips. Holds well enough, but you can get them off if you need. Of course, after installing mine the first time with glue, I put on a different set of bars, so I've been down that road.
Al
|
|
|
Re: Any tricks to installing ISO grip
|
Joined: Mar 2005
Posts: 2,419
Oil Expert
|
|
Oil Expert
Joined: Mar 2005
Posts: 2,419 |
I just did mine. I was able to peel them off inside out without cutting - just used a screwdriver to loosen them.
Cheers, Richard
~~~~~~~~~~~~
09 America, Staintune Pipes, K&N, Breathe, Hagon Nitros, AI & O2 removed, tune 20184 (modified), MTX-L a/f gauge
|
|
|
Re: Any tricks to installing ISO grip
|
Joined: Sep 2009
Posts: 106
Adjunct
|
|
OP
Adjunct
Joined: Sep 2009
Posts: 106 |
Thanks guys...........................V.
|
|
|
Re: Any tricks to installing ISO grip
|
Joined: Jan 2005
Posts: 570
Adjunct
|
|
Adjunct
Joined: Jan 2005
Posts: 570 |
Be careful with the glue that comes with the grips. It's instant stick, so test apply and mark where you want the left side to end up. I purchased a slower drying glue that gave me time to position the grips where I wanted them.
Last edited by Shutterbug; 11/10/2009 7:42 PM.
"You're a long time underground!"
|
|
|
|
|
|
|
