Quote:

If you can, get the one that will fit over the stock throttle sleeve. If you can't, keep the stock one handy on trips.



I got the ones that fit over the stock throttle sleeve. They DON'T fit the throttle sleeve out of the box. I had to dremmel the ribs off the stock throttle sleeve PLUS about 1.5mm (1/16") off the stock sleeve. Even then it was extremely tight fit and no glue was necessary. I had to use soap to get them on and the rubber required a lot of re-adjusting to get it back in its proper position. The left grip fits right out of the box and required glue.

These are the Kuryakyn ISO-flame grips part #6262.

Note: Kuryakyn don't say this part will fit our Triumphs. They do say the #6236 will fit our bikes but the 6236 is the complete throttle sleeve grip which has prematurely broken for some on this forum.

I figured that because both the 6262 and the 6236 fit the Honda cruisers then the 6262 would also fit our bikes. I was wrong. The Honda cruisers must have a smaller diameter throttle sleeve. Still, they do fit with some modding.

Cheers, Richard
~~~~~~~~~~~~
09 America, Staintune Pipes, K&N, Breathe, Hagon Nitros, AI & O2 removed, tune 20184 (modified), MTX-L a/f gauge