Powder Coating Lower Forks

Check out the new Gallery

wicked red 1100
by mag10, August 21

first ride
by NemoJr, April 1

Steve McQueen inspired
by Feral, November 28

GaRally22
by chy, September 18

Print Thread

Re: Powder Coating Lower Forks rebelraider #346526 07/29/2009 2:43 PM
Joined: May 2008 Posts: 247 Delaware, U.S.A. Chip Adjunct
Chip Adjunct Joined: May 2008 Posts: 247 Delaware, U.S.A.	Powder coating ovens get up 450*. Any rubber or non metalic parts will be trash when there done and they would run into the finish destroying your powdercoating. The answer is yes, take them compleatly apart. Chip Sciarra "07" America, N.C.Switch Blade windshield, Moto Lights, Tri. Off Road pipes

Entire Thread
Subject	Posted By	Posted
Powder Coating Lower Forks	thriftmaster	07/29/2009 2:44 AM
Re: Powder Coating Lower Forks	roadworthy	07/29/2009 3:02 AM
Re: Powder Coating Lower Forks	baboon	07/29/2009 3:13 AM
Re: Powder Coating Lower Forks	FriarJohn	07/29/2009 5:20 AM
Re: Powder Coating Lower Forks	thriftmaster	07/29/2009 4:19 PM
Re: Powder Coating Lower Forks	rebelraider	07/29/2009 4:25 PM
Re: Powder Coating Lower Forks	Chip	07/29/2009 6:43 PM
Re: Powder Coating Lower Forks	thriftmaster	07/29/2009 6:50 PM
Re: Powder Coating Lower Forks	FriarJohn	07/29/2009 7:42 PM
Re: Powder Coating Lower Forks	thriftmaster	07/30/2009 9:15 PM
Re: Powder Coating Lower Forks	FriarJohn	07/30/2009 10:10 PM

Moderated by bennybmn, chy, mert

Link Copied to Clipboard

2025 Arkansas Rally
by roadworthy - 04/24/2025 7:57 PM

Bonneville America Forums Forums Technical Forums General Tech Powder Coating Lower Forks