Okay, that was a one hour exercise in frustration. I had it on, but the throttle bound at the very end of movement (Wide open).
So, I'm starting from scratch with these questions:
1. There is almost no room to slip in the rubber strip from the front. I put it in from the rear, but it doesn't seem to be making contact with the set screws. I think they are up against the chrome grip housing. Is that strip put in from the front? If so, tips are appreciated.
2. The release cam doesn't seem to be high enough, so I put on the cam extension - are you guys using it?
3. The distance to the lever pivot bolt doesn't seem right, so I added that extra block longer screw. Are you guys using it?
Any detailed pix of the installed unit would be highly appreciated. Particularly from where it secures to the lever pivot bolt.
Geez, seemed simple enough......
