Check out the new Gallery
wicked red 1100
wicked red 1100
by mag10, August 21
Windshield I need to replace
Windshield I need to replace
by philwarner, May 10
first ride
first ride
by NemoJr, April 1
Steve McQueen inspired
Steve McQueen inspired
by Feral, November 28
GaRally22
GaRally22
by chy, September 18
Previous Thread
Next Thread
Print Thread
TPS issues
#333382 05/21/2009 5:46 PM
Joined: May 2006
Posts: 277
skid Offline OP
Adjunct
OP Offline
Adjunct
Joined: May 2006
Posts: 277
OK, I know that there are a few out there that have had issues with the TPS sending a crap signal and causing premature engine shutdown at under redline.... My 03 speedy started shutting down at redline instead of just dropping a cylinder and then the engine started cutting out intermittently about 7000 RPM.... Well, disconnected the TPS today and the bike seems to have more power than it has ever had since I bought it last June.. Just wondered if everyone that has disconnected their TPS has left it unhooked, or eventually replaced it..... Is there any issue with leaving it disconnected? I kind of assume that there is not an issue since if you get flat slides or other aftermarket carbs, you dont have one to hook up....
Mark

Re: TPS issues
skid #333383 05/21/2009 6:16 PM
Joined: May 2007
Posts: 6,432
Likes: 1
Worn Saddle
Offline
Worn Saddle
Joined: May 2007
Posts: 6,432
Likes: 1
It would be a totally out of warrantee thing to adjust but:

Quote:

TPS readings from a showroom bike are (with the idle adjustment completely slacked off):
Blue & Yellow wires = 4.42K OHMS (4.40-4.44) closed throttle &
1.38K OHMS (1.36-1.40) wide open throttle.
Black & Yellow wires = 0.81k OHMS (0.79-0.83) closed throttle &
3.96k OHMS (3.94-3.98) wide open throttle.




Who's to say yours isn't just a wee bit out of adjustment?


A positive attitude may not solve all your problems, but it will annoy enough people to make it worth the effort. Herm Albright (1876 - 1944)
Re: TPS issues
oldroadie #333384 05/22/2009 3:32 AM
Joined: Apr 2007
Posts: 3,063
Likes: 8
Loquacious
Offline
Loquacious
Joined: Apr 2007
Posts: 3,063
Likes: 8
I've left mine disconnected for several months of riding with no problems. I disconnected it last summer because the bike would cut out at times off idle just like it was hitting the rev limiter as you stated. Checked the TPS resistance readings and things were messed up probably due to some water getting inside after washing the bike. The few times I have hooked it back up things work well...

My main reason for not hooking the TPS back up permanently is that the bike doesn't pop on decel with it disconnected which is something I really like.

The CDI unit was just modded to run up to 8500 rpm by Pieman. I haven't reached the cut off point yet to see if it shuts down the same as before (No need to rev the bike that high since it runs out of steam around 7600 rpm).

Adjustment for TPS is in the Tech vault or on Pieman's website http://www.triumphtwinpower.com/tps_adjustment.php


12 Rocket Roadster
03 Bonneville America
69 BSA Firebird Scrambler
73 Yamaha TX 750
Re: TPS issues
skid #333385 05/22/2009 11:04 AM
Joined: Jan 2005
Posts: 8,639
Likes: 3
Old Hand
Offline
Old Hand
Joined: Jan 2005
Posts: 8,639
Likes: 3
My guess is that a totally incorrect reading from the TPI would send the ignition to an advance curve that is unprogrammed. With the TPI unplugged, it will only select one curve, probably a generic one specially for a TPI failure.


Let's hope there's intelligent life somewhere in space 'cause it's buggar all down here. -- Monte Python
Re: TPS issues
Greybeard #333386 05/22/2009 1:47 PM
Joined: May 2006
Posts: 277
skid Offline OP
Adjunct
OP Offline
Adjunct
Joined: May 2006
Posts: 277
Well, I checked the readings, and it was off... I adjusted it and now it shuts down around 7200-7300, instead of at 7000.... Still not where it should be... I did not find any eroneous data coming from the pot.... Oh well, I will see how it runs on our 1500 mile trip next week... If it acts up, then I will just unplug it again and leave it that way...

Re: TPS issues
skid #333387 05/22/2009 7:16 PM
Joined: Jan 2009
Posts: 1,228
I live in the sun downunder
Offline
I live in the sun downunder
Joined: Jan 2009
Posts: 1,228
Quote:

OK, I know that there are a few out there that have had issues with the TPS sending a crap signal and causing premature engine shutdown at under redline.... My 03 speedy started shutting down at redline instead of just dropping a cylinder and then the engine started cutting out intermittently about 7000 RPM.... Well, disconnected the TPS today and the bike seems to have more power than it has ever had since I bought it last June.. Just wondered if everyone that has disconnected their TPS has left it unhooked, or eventually replaced it..... Is there any issue with leaving it disconnected? I kind of assume that there is not an issue since if you get flat slides or other aftermarket carbs, you dont have one to hook up....
Mark




You can't replace the TPS. You have to buy new carbies.


FrankW Ex Speedmaster rider, went to the Dark Side now riding an America.
Re: TPS issues
FrankW #333388 05/23/2009 10:51 PM
Joined: Jan 2005
Posts: 1,018
Learned Hand
Offline
Learned Hand
Joined: Jan 2005
Posts: 1,018
Mine has been disconnect for several years. It started acting up and shutting down and I just disconnected it and left it that way. No problems since.


Moderated by  bennybmn, chy, mert 

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.4