I didn't see any lines that looked pinched when I had it apart. I did pull the fuel pump plate off the tank and replace the fuel filter while I had it off the bike. Cleaned out a little bit of crud in the tank while I was in there (but not too much). Replaced the air filter, and cleaned some carbon build-up off the throttle bodies. I tried to sync the throttle bodies...but the Motion Pro Pro Sync and I weren't working on the same page last night (it might end up listed in the classified section soon...or the trash can).
So, I just put it all back together and filled it up with fresh gas and took it around the block a few times. It ran great, but the temp was down in the 70's by the time I was out. Supposed to hit close to 90 for the next few days, so I'll see what happens then.
Thanks everyone for the ideas and plug reading help.
Will
