Quote:

I thought the concave shot was the side where the spring would push against

It is...the part that would be the top also has a very shallow machined step into it. I just dont see the concern.

Granted I dont have the time on my bike like some of you guys but does the area behind the motor (where these carb caps would actaully be) get that dirty? Same goes for water spray (unless your cleaning your bike).

I would imagine that if you spend $115 bucks on this that your probably also ok with wiping the area down every once in a while.

SOLD: 07 Black BA, 39mm FCRs, TPUSA stage 1 head, TPUSA 813 cams, TPUSA 10.8:1 pistons, TTP #3 igniter, Specialty Spares Long Cannons, Tsukayu Hard Bags. 82HP/55tq NEW: 19 Goldwing Tour DCT