Bonneville America Forums Forums Technical Forums General Tech Horns

Tips:

I mounted the Stebel in the same location as the stock horn using the stock horn bracket. I added a lug to the positive battery terminal and installed an inline fuse under the seat. The relay is mounted on the forward-most threaded hole where the AI controller was previuosly installed. The relay lugs face forward, and the stock horn wires/lugs reach back to the relay and fit the relay lugs without modification. The rear AI hole holds the new ground lug for the wire trunning to the Stebel. All the wires that I ran up the harness are black for a neater appearance. All added wires are tie-wrapped (black ties) to the harness and routed so that they don't rest against any metal surfaces. I slid a length of heat shrink over the two new wires where they are routed through the opening between upper and lower triple tree on their way to the horn.

Next time I have the seats and tank off, I'll try to photograph the work.

Jack