Quote: Hi again, are there any modifications on the tank necessary.
I like the look of the Bonnie tank, it gives the bike a slimmer look which is what I was going for. As far as the mods, I had to use a hammer on the back bottom of the tank to widen in out some. A little on the petcock side being careful not to damage the petcock holes and more on the oposite side just enough to fit. I also had to cut a 1/4 of an inch or so off of the mounting brackets on the frame. I also had to relocate the relay and ingnitor box under the top fram tube with electrical tape(temporary).
