Wendys is installed so that they come on with her high beam and off with low beam. I took an auto bulb and soldered a wire to the side and one to the center contact to make a simple test light. Then inside the headlight bucket I turned on the headlight on high beam and tested each wire at the plugs until I found one that was hot with high beam on and not hot when high beam was off. Went back a little from the plug and stripped off some insulation and soldered the pos. light bar wire in. You could do the same to find one hot when key is on and not when off just watch what you connect to that you don't over load a fuse. Wendys had worked great for years and 13,000 miles now.

I learned all I need to know about life by killing smart people and eating their brains.
Eat right ,Exercise ,Stay fit, Die Anyway!