|
|
 Check this out
|
Joined: Jan 2005
Posts: 7,643
Monkey Butt
|
OP
Monkey Butt
Joined: Jan 2005
Posts: 7,643 |
Was bored tonight so decided to put these brake lights on  
Ray(UK)
|
|
|
Re: Check this out
|
Joined: Jan 2005
Posts: 3,753
Loquacious
|
|
Loquacious
Joined: Jan 2005
Posts: 3,753 |
those are pretty bright
Frank
(Former)05 BA tbike pipes, ai removed, Freak, mikuni hsr 42's, 904, ported/polished head, 1mm oversized valves
NOW-2010 silver and black tbird
|
|
|
Re: Check this out
|
Joined: Apr 2008
Posts: 4
Complete Newb
|
|
Complete Newb
Joined: Apr 2008
Posts: 4 |
those are pretty cool did you buy those online? if so hook me up with a site.
|
|
|
Re: Check this out
|
Joined: Aug 2005
Posts: 2,525
Loquacious
|
|
Loquacious
Joined: Aug 2005
Posts: 2,525 |
Erwin
05 America
|
|
|
Re: Check this out
|
Joined: Jan 2005
Posts: 12,164 Likes: 1
Should be Riding
|
|
Should be Riding
Joined: Jan 2005
Posts: 12,164 Likes: 1 |
Cool! The more lights the better!
Soren
|
|
|
Re: Check this out
|
Joined: Jul 2006
Posts: 763
3/4 Throttle
|
|
3/4 Throttle
Joined: Jul 2006
Posts: 763 |
oooh I like those. Just need to hope local plod does not become anal about the overlap of your numbers ....how easy is the wiring of them.. where did you run it...we need pictures from behind the number plate ....
|
|
|
Re: Check this out
|
Joined: Jan 2005
Posts: 7,643
Monkey Butt
|
|
OP
Monkey Butt
Joined: Jan 2005
Posts: 7,643 |
Bought off eBay from taipei_scooter_assassins.  Very easy to wire up, but a little fiddly. I ttok them in the space behind the number plate at the side of the bracket and covered the wires from the bolt to the inside with rubber shielding. I then threaded them through the back of the reg plate holder to the inside on the fender. I then wired them up together and soldered the joint to give me two wires instead of eight. I then put shielding to cover from the reg plate down following the rear tail light wires, and then threaded them through to the rear brake. I then broke into the EARTH (BLACK) and also the LIVE (BLUE) soldered the joints and wrapped them in PVC tape. sealed the holes on the inside of the fender with copper coat to stop water penetrating..
Ray(UK)
|
|
|
Re: Check this out
|
Joined: Jan 2005
Posts: 7,643
Monkey Butt
|
|
OP
Monkey Butt
Joined: Jan 2005
Posts: 7,643 |
 As you can see in this pic the shielding goes through to the inside of the reg plate rubber(not into the inside of the chrome bracket) and also through to the inside of the tail light rubber. The copper coat is to prevent rust I never bothered on the 04, just did the bolts but the rear mudguard (fender) was rusty.
Ray(UK)
|
|
|
|
|
|
|
