Dont know about you folks but my butt isnt square.
If your willing to drop 600 on a seat then you should check out a custom seat builder like:
Richs Bill Mayer Sargent Anyway...I went to Richs cause I live close enough to go in for a custom fitting. The first time he did my saddle it was a drop off. He did a nice job, sat me further back, comfy riding position but it was causing some numbness. I went in when I got back from Nelson and he reworked it. I learned a few things about our seat pans during this fitting.
1) our seats set us far up
2) when you move the rider back the seat pan has a drastic upward angle at the rear due to how low the oem seat sets the rider
3) the basic solutions are to raise the set height to get enough clearance so your tail doesnt press agains the seat pan or move further forward. I am 6-1 and moving forward was not an option for me so I went up.
My seat after todays fitting and adjustment is a night and day difference. With teh oem seat I could go maybe 20 miles before gettign a hot spot. I had a Corbin for a while and it looked better than OEM but I was done by @40 miles. Todasy test ride went 50 miles and I did not feel any fatigue at all.
My seat is big...its tall but it feels like heaven. Ill post a pic tomorrow so you can see.
I guess my point is for that money you should get more than just a generic seat.
BC is cool...very cool web site but they are right at retail on everything.
