Bonneville America Forums Forums Technical Forums Custom Corner My chopped up Speedmaster

Ok, lets see where to start...Awesome on the screensaver! Thats a first for me! The cable length-I dont remember what I used. Just mock up your bars and then runa piece of yarn the exact way you want to run your cables, take it off, measure and call Motion PRO and get your order in. All in all it cost me about 175 bucks with shipping included and I had them in just a few days! The battery box- you have to cut your stocker up and use part of the stock airbox as well. PM oldroadie (Ed), he has the specs and a diagram of what you need to do with measurements. The seat-bought it off Ebay for 20 or 30 bucks. Do a search for custom Harley/Triumph solo seat and you will find a million. It comes with 2 bolts attached to the uderside of the seat. I cut one off and then simply ran a piece of 3/8 inch steel from under the gas tank bolt to that bolt on the seat. The back of it I mounted 2.5 inch springs and then tapped in some double threaded car water pump bolts to the frame. The springs sit right down on top of them and is secure as can be! The wiring under the seat-I pulled back the wiring harness and the protective coating and just made some slack in the wires and then black zip tied them to the frame out of site for that Clean look. All was VERY easy to do! Now just wait until I get the whitewalls, the new red wine leather for the seat and matching hand grips! THANKS to all for the comments (good or bad welcome!) this site really is the reason I have done all that work!