Register Log In

Bonneville America Forums Forums Technical Forums General Tech brake caliper

Check out the new Gallery

wicked red 1100

wicked red 1100
by mag10, August 21

Windshield I need to replace

Windshield I need to replace
by philwarner, May 10

first ride

first ride
by NemoJr, April 1

Steve McQueen inspired

Steve McQueen inspired
by Feral, November 28

GaRally22

GaRally22
by chy, September 18

Print Thread

brake caliper #257196 04/21/2008 2:40 PM
Joined: Feb 2006 Posts: 223 3spirit OP Adjunct
OP 3spirit Adjunct Joined: Feb 2006 Posts: 223	hi rounded off the hex bolt that holds the front brake pads on tried heating it , and wd40 but its stuck tight any ideas thanks lowered 2 in stretched front ,widened front forks, aubergine black pearl paint 40 ford rear light standard exhaust all baffels removed, pods, 155 main, 45 pilot, thruxton needle, 16 tooth sprocket procom ignitor set to no 5

Re: brake caliper 3spirit #257197 04/21/2008 2:47 PM
Joined: Feb 2007 Posts: 23,176 Likes: 55 NE PA USA The_Dog33 Fe Butt
The_Dog33 Fe Butt Joined: Feb 2007 Posts: 23,176 Likes: 55 NE PA USA	you can drive a torx bit in there, the hammer action may help knock it loose and the torx bit will grab pretty well inside the hex bolt. This is best done with an impact quality torx bit. Be careful not to hit on the caliper hard enough to bend or break anything. I learned all I need to know about life by killing smart people and eating their brains. Eat right ,Exercise ,Stay fit, Die Anyway!

Moderated by bennybmn, chy, mert

Link Copied to Clipboard

Powered by UBB.threads™ PHP Forum Software 7.7.4