Check out the new Gallery
wicked red 1100
wicked red 1100
by mag10, August 21
Windshield I need to replace
Windshield I need to replace
by philwarner, May 10
first ride
first ride
by NemoJr, April 1
Steve McQueen inspired
Steve McQueen inspired
by Feral, November 28
GaRally22
GaRally22
by chy, September 18
Previous Thread
Next Thread
Print Thread
How much time to change jets ?
#256181 04/17/2008 6:49 PM
Joined: Apr 2008
Posts: 1
Complete Newb
OP Offline
Complete Newb
Joined: Apr 2008
Posts: 1
Hello all, I am going to install new pipes and rejet on a 03 speed master, can any one give me som tip's I have done this on many bikes before so all set once the carbs are out. Do i need to remove air box to get carbs out? How much time does this take. any secret time savers?
Thanks much

Re: How much time to change jets ?
sledjunky #256182 04/18/2008 12:33 AM
Joined: Jun 2007
Posts: 39
Greenhorn
Offline
Greenhorn
Joined: Jun 2007
Posts: 39
try to go to www.dinqua.com all info there


Do you Know Him or do you Know about Him?
Re: How much time to change jets ?
sledjunky #256183 04/18/2008 10:20 AM
Joined: Jan 2005
Posts: 12,877
Should be Riding
Offline
Should be Riding
Joined: Jan 2005
Posts: 12,877
How good are you at dislocating your thumbs? That will make things much easier...


Benny Black & Silver '02 Too many mods to list Not enough miles ridden
Re: How much time to change jets ?
sledjunky #256184 04/19/2008 10:35 AM
Joined: Mar 2007
Posts: 5,616
Check Pants
Offline
Check Pants
Joined: Mar 2007
Posts: 5,616
I followed Dinquas instructions and was done in about an hour or so...mind you it was my first go at working on a MC and more so keeping the carbs on.

Get the carb screws from Brent before you start. Not a must but nice if you strip one of those soft oem screw heads.


SOLD: 07 Black BA, 39mm FCRs, TPUSA stage 1 head, TPUSA 813 cams, TPUSA 10.8:1 pistons, TTP #3 igniter, Specialty Spares Long Cannons, Tsukayu Hard Bags. 82HP/55tq NEW: 19 Goldwing Tour DCT
Re: How much time to change jets ?
Zmilin #256185 04/19/2008 10:48 AM
Joined: Feb 2007
Posts: 23,219
Likes: 61
Fe Butt
Offline
Fe Butt
Joined: Feb 2007
Posts: 23,219
Likes: 61
Cheaper and faster to just go to Ace Hardware and buy stainless allen head screws.


I learned all I need to know about life by killing smart people and eating their brains.
Eat right ,Exercise ,Stay fit, Die Anyway!
Re: How much time to change jets ?
The_Dog33 #256186 04/19/2008 11:14 AM
Joined: Apr 2007
Posts: 3,063
Likes: 8
Loquacious
Offline
Loquacious
Joined: Apr 2007
Posts: 3,063
Likes: 8
I've done it both ways - Carbs off and on. Quicker to perform the work with them on but a couple of screws are hard to access. Try with them on and if you strip a screw for the bowl, slide the air box back and pull the carbs.


12 Rocket Roadster
03 Bonneville America
69 BSA Firebird Scrambler
73 Yamaha TX 750
Re: How much time to change jets ?
Gregger #256187 04/19/2008 3:01 PM
Joined: Feb 2007
Posts: 23,219
Likes: 61
Fe Butt
Offline
Fe Butt
Joined: Feb 2007
Posts: 23,219
Likes: 61
I had a stubborn pilot jet one time that I couldn't get out when I did it on the bike,l had to pull the carbs to get it out.Also think it is easier to pull them the first time to learn where everything is.


I learned all I need to know about life by killing smart people and eating their brains.
Eat right ,Exercise ,Stay fit, Die Anyway!
Re: How much time to change jets ?
sledjunky #256188 04/22/2008 1:50 PM
Joined: Jan 2005
Posts: 1,485
Learned Hand
Offline
Learned Hand
Joined: Jan 2005
Posts: 1,485
I find that pulling the tank and carbs works best for me. Got open pods so I don't have to mess with the carb/airbox connection. And balancing is easier with the tank off. Switched out the pilots, balanced and reasembled last week in 1.5 hours. And yup the allen head carbs screws are the way to go.


"Despite all the amputation, you could dance to a rock 'n roll station..."
Re: How much time to change jets ?
sledjunky #256189 04/22/2008 3:16 PM
Joined: Jan 2005
Posts: 11,126
Likes: 13
moe Offline
Should be Riding
Offline
Should be Riding
Joined: Jan 2005
Posts: 11,126
Likes: 13
pete can knock it out in 20 minutes.



Blowing gravel off rural roads
Re: How much time to change jets ?
The_Dog33 #256190 04/22/2008 9:23 PM
Joined: Mar 2008
Posts: 57
Member
Offline
Member
Joined: Mar 2008
Posts: 57
Do you know what size screws?


2007 America Pacific Blue and New England White, AI removed, Freak Kit, Bubs long slash cut, 160 mains.
Re: How much time to change jets ?
BillinOK #256191 04/22/2008 10:10 PM
Joined: Feb 2007
Posts: 23,219
Likes: 61
Fe Butt
Offline
Fe Butt
Joined: Feb 2007
Posts: 23,219
Likes: 61
4mm X 0.7 thread , Phil knows the lengths, I forget them.


I learned all I need to know about life by killing smart people and eating their brains.
Eat right ,Exercise ,Stay fit, Die Anyway!
Re: How much time to change jets ?
The_Dog33 #256192 04/23/2008 1:19 PM
Joined: Jan 2005
Posts: 9,223
Big Bore
Offline
Big Bore
Joined: Jan 2005
Posts: 9,223
here ya go:

M4 x 14
M4 x 8

8 each


"Never underestimate the power of human stupidity" - Robert Heinlein

Moderated by  chy, Dinqua, freedom 

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.4