I have mounted the red LED silver bullets and tombstone tail light on the back of my bike with no problem. I mounted the amber LED silver bullets to the turn signal relocater bracket I bought from Ma's. Here is the problem: the amber LED's have 3 wires (black, blue and violet. The Triumph pumpkins only have 2 wires each from what I can see, similar to the rear blinkers. I connected the black and violet wires to the wires from the existing pumpkins and left the blue wire alone. Then installed the load equalizer as I did for the rear blinkers. Now when I put switch the right or left turn signal on, both blink on the front and both blink on the rear. Normal speed blinking, not the rapid blinking the instructions warn about. Any ideas what I have done wrong? I'm sure I am not the first to try these on the front and back together. Please help this electronic illiterate.
