its pretty easy....
* remove top nut
* loosen bolts at top yoke
* carefully remove top yoke assembly (no need to remove any cables)...it wont pull off easy, I had to shimmy it or use soft taps from a dead blow hammer.
* slide shrouds off...use a touch of WD40 to lube the rubber boots.
* reverse above.
note...if you have a lift its eaier to repalce the top yoke assembly cause it takes pressure off the front end. If not then lightly tap the top yoke into place if its sticking.
SOLD: 07 Black BA, 39mm FCRs, TPUSA stage 1 head, TPUSA 813 cams, TPUSA 10.8:1 pistons, TTP #3 igniter, Specialty Spares Long Cannons, Tsukayu Hard Bags. 82HP/55tq
NEW: 19 Goldwing Tour DCT
| 
