I installed a pro 1
universal loop this weekend. I like it. If anyone is interested it did require some simple mods to get it to mount.
1. The TBA speedo cable is too large on both ends to fit through the loop. I had to file 2 slight flat spots opposite each other in the knurled end that screws into the speedometer. Once filed the speedo cable can be threaded through the loop. Don't go crazy with the file, just bring down enough to get the screw end through.
2. The hole in the fender from the rubber mount is about 1/2 inch in diameter, too big for the loop's screw. So I cut the rubber off flush with the fender and used the remaining plug as a spacer. This worked out well because the loop is now rubber mounted and has a little give to it.
3. My speedo cable was routed very tight under a few wires near the gas tank. With the speedo end disconnected I pulled it though the wires and just let it hang free when I reconnected it to the speedo. I then zip tied it to the wire bundle. This seems to let the cable to hang a lot looser and cause much less stress at the loop.
Picture attached for your viewing pleasure!
